Kenosha Reuse Discussion Board > WAUKEEGAN, IL
> Commercial
> Automative
> Refurbished
> No Warranty
> 1 1/4" potable pex 500' - 1 roll of 500' red
1 1/4" potable pex 500' - 1 roll of 500' red
1 1/4" WITHOUT OXYGEN BARRIER PEX USED FOR POTABLE WATER
WE WILL BEAT ALL COMPETITOR PRICES
This listing is for boxed, brand new, fresh production of 500 ft (FIVE HUNDRED feet) 1" cross-linked Polyethylene (PEX) without Oxygen Barrier.
Contact us for other quotes in length or size requirements. We also carry 3/8", 1/2", 5/8", , 1" and 1 ID with and without O2 barrier.
This PEX will fit all ASTM/NSF/CSA fittings. If you get a kink, you can remove kinks with heat. Can take pressure and return to the original shape. Same goes with freezing. If water freezes, the PEX is designed to expand without bursting and return to original shape when it thaws. This is the greatness of cross-linked polyethylene.
* Inside diameter in accordance to SDR9 (See SDR9 Chart below)
* Available Colors: Red for Oxygen Barrier PEX and Red, White, Blue for non Barrier
* Oxygen barrier is encased with the walls of the pipe, protecting the layer from physical or ultraviolet light damage. This protected layer renders the pipe virtually resistant to gasses getting into the line.
* All tubing is marked every 3 feet so there is no measuring or guessing in the length. The marks are designated in FTXXX where XXX is the foot number of the spool. Example. If you need 300ft of a 900ft spool, you start at beginning and make cut at FT300.
* Good flexibility. See Chart below for minimum bend radius
All Rolls are fresh production packaged in heavy duty Box.
* PEX Radiant tubing can be used in concrete slabs, under floor, under raised floor, outdoor concrete slabs or ground to melt ice or snow, and solar heating through the building.
* The Radiant tubing can also be used for PEX for potable water since it has all the NSF certifications
* Compatible with all fittings such as compression fittings, crimp fittings, and expansion fittings such as Wirsbo fittings that IAW SDR9 sizes
* Although the PEX has UV resistance, PEX should not be placed in the sun or have UV exposure.
QUICK REFERENCE CHART IAW ASTM AND SDR:
ASTM standard PEX Tubing, ASTM F-876/F-877/CTS-OD SDR9
Pipe has been developed, tested and approved for central, solar, and under the floor heating systems and also for hot and cold potable water service to the following standards which are all marked on the tubing. As required by codes, all certifications are labeled on the PEX.
Gives requirements for crosslinked polyethylene pressure tubing systems. Components that are covered in this standard are meant for use in residential and commercial hot and cold potable water distribution systems, also sealed central-heating (including under-floor) systems.
This Standard is intended to cover specific materials or products that come into contact with: drinking water, drinking water treatment chemicals, or both. The focus of the Standard is evaluation of contaminants or impurities imparted indirectly to drinking water.
The physical, performance, and health effects requirements in this Standard apply to thermoplastic and thermoset plastic piping system components, including but not limited to pipes, fittings, valves, joining materials, gaskets, and appurtenances. The established physical, performance, and health effects requirements also apply to materials (resin or blended compounds) and ingredients used to manufacture plastic piping system components. It provides definitions and requirements for materials, ingredients, products, quality assurance, marking, and record keeping
We are able to handle any volume order over 10,000ft. Contact us for more information and large volume discounts.
Click to see other PEX listings.
