Kenosha Reuse Discussion Board > WAUKEEGAN, IL
> Commercial
> Automative
> New
> No Warranty
> Miller 907437 millermatic reach 6 foot wire feeder
Miller 907437 millermatic reach 6 foot wire feeder
Use the Reach with your Millermatic 212 Auto-Set, 252, or 350/350P to extend your work area or to create a dual feeder, avoiding downtime from changing wire spools.
Extend your Millermatic work area up to 40 ft ( with the 25' model) ! No more moving the machine and pulling primary power cables around the shop.
Use as a dual feeder option! Keep one wire in the machine and a different wire in the feeder. No more downtime changing spools and drive rolls.
Auto-Gun Detect when connected to a Millermatic 252 or 350P, simply pull the
trigger on either gun and the Millermatic
machine will recall both voltage & wire feed
Synergic Pulse Capability when connected to Millermatic 350P. Remotely change weld output by simply adjusting wire feed speed setting at the feeder.
Patent-pending Hybrid Technology
connects to Millermatic 10-pin connector and
Polypropylene case with built-in slide rails gives you the ability to easily change wire when in vertical position.
Double-filtered gas valve helps keep dirt from clogging and affecting gas flow.
Works with any Miller-compatible MIG gun (MIG gun sold separately)
Compatible with the following Millermatic models:
*with Millermatic 350P model only
* 14 32 Operating Voltage,
* 50-700 IPM (1.3 17.8 m/min)
* .023 .052 in (0.6 1.3 mm)
* 45 lb (20.4 kg), 12 in (304 mm)
* 29 lb (13.2 kg) with 6 ft cable
* 48 lb (21.8 kg) with 25 ft cable
