Kenosha Reuse Discussion Board > SOMERS, WI
> Commercial
> Mechanical
> Refurbished
> Rockwell 10" cabinet lathe operating/parts manual
Rockwell 10" cabinet lathe operating/parts manual
This is a reproduction, not a photocopy, of an original Rockwell 10" Metal Cutting Lathe Instructions and Parts Manual. As you can see from the contents, this is a very detailed manual that covers everything you would want to know about this machine.
INTRODUCTION....................................................................1
Unpacking.......................................................................3
Cleaning the Lathe..............................................................3
Selecting Floor Space...........................................................3
Installing the Motor............................................................3
Leveling the Lathe..............................................................4
Aligning Bed Ways Parallel to Headstock Spindle (Cabinet Models Only)...........4
Location of Floor Mounting Holes................................................4
Electrical Recommendations......................................................5
NOMENCLATURE CHART..............................................................6
Headstock Controls..............................................................8
Outboard Gear Train.............................................................9
Variable Speed Drive............................................................9
Carriage.......................................................................10
Quick Change Gear Box..........................................................12
Tailstock......................................................................13
Adjusting Back Lash............................................................14
Gib Adjustment for Compound Slide..............................................15
Gib Adjustment for Cross Slide.................................................15
Compound Slide Feed Screw End Play Adjustment..................................16
Cross Slide Feed Screw End Play Adjustment.....................................16
Power Feed Clutch Adjustment...................................................16
Replacing Shear Pin in Lead Screw..............................................17
Lead Screw Adjustment..........................................................17
Variable Speed Underneath Drive
Adjustment to Variable Speed Control Lever.....................................18
Belt Alignment.................................................................18
Belt Tension...................................................................19
Adjustment to Variable Speed Handwheel Screw...................................20
Belt Alignment.................................................................20
Belt Tension...................................................................20
Lubrication....................................................................21
Replacing Spindle, Spindle Pulley, Spindle Bearings, & Bull Gear...............22
Replacing Feed Reverse Lever...................................................24
Replacing and Adjusting Back Gears.............................................24
Belt Drive System (Underneath Drive Models)
Replacing Variable Speed Belts, Variable Speed Pulleys,
and Upper Jackshaft Pulley.....................................................26
Replacing Spindle V-Belts......................................................27
Belt Drive System (Rear Drive Models)
Replacing Variable Speed Belts, Variable Speed Pulley,
and Upper Jackshaft Pulley.....................................................29
Replacing Spindle V-Belts......................................................30
Replacing Variable Speed Screw and Nut.........................................30
Replacing Left and Right Hand Tumblers.........................................31
Replacing Compound Slide Feed Screw and Nut....................................32
Replacing Cross Slide Feed Screw and Nut.......................................33
Replacing Half Nuts............................................................34
Replacing Lead Screw...........................................................34
Replacing Power Feed Clutch and Worm...........................................35
Parts List and Diagrams.....................................................36-56
