Kenosha Reuse Discussion Board > SOMERS, WI
> Commercial
> Automative
> Used
> Flux cored E71T-1C TRIPLE7 mig welding wire .045 33 lb
Flux cored E71T-1C TRIPLE7 mig welding wire .045 33 lb
Flux cored E71T-1C Triple7 MIG welding wire .045 33 lb
Hobart Miller Tri-Mark Triple 7 Welding Wire
This is one brand new 33 lb roll of .045 gauge Flux cored, gas shielded wire suitable for carbon steel and some higher strength steels. It is intended for single and multiple pass welding in all positions and has a fast-freezing slag that permits the welder to use higher current to deposit more metal faster and still produce a flat bead in all positions. The slag removes easily even from deep groove welds and spatter is low, so a welder spends more time welding and less time cleaning up. Suitable for general plate fabrication, heavy gauge sheet metal, pressure vessels, and certain pipe welds.
Excellent weld with 100% CO2 or 75% Ar/25% CO2.
A fast-freezing slag permits the welder to use higher current to deposit more metal faster and still produce a flat bead in all positions.
Slag removes easily, even from deep groove welds.
Spatter is low, so a welder spends more time welding and less time cleaning up.
E71T-1C H8, E71T-1M H8 per AWS A5.20, ASME SFA 5.20
100% CO2, 75% Ar/25% CO2, 35-50 cfh
TYPICAL MECHANICAL PROPERTIES*:
Tensile Strength 90,000 psi (617 MPa) 93,000 psi (643 MPa)
Yield Strength 79,000 psi (547 MPa) 79,000 psi (545 MPa)
CVN @ 0 F (-18 C) 76 ft lbs(103 J) 63 ft lbs (85 J)
* see enclosed documentation, information is typical not guaranteed.
Each roll is individually sealed in a plastic bag as shown and boxed.
Please ask questions before purchasing this item. Thank you!
