Kenosha Reuse Discussion Board > SOMERS, WI
> Commercial
> Automative
> Refurbished
> Plus Warranty
> Williams boring bar holder+bar for 9"-10" south bend
Williams boring bar holder+bar for 9"-10" south bend
Offered here is a Williams Boring Bar Holder, type 080. The holder was intended for use on a 10" South Bend Lathe, but it does not appear to have been used very much. The shank size is 3/8" wide x 3/4" high, so it should also be suitable for use on 9" model lathes. The boring bar and wrench shown in the picture are included.
