Kenosha Reuse Discussion Board > SOMERS, WI
> Commercial
> Automative
> Refurbished
> Plus Warranty
> New murkens #1 surface gage w/ interapid .0005 machinist
New murkens #1 surface gage w/ interapid .0005 machinist
MURKENS #1 SURFACE GAGE. 2 MONTHS OLD! DIRECTLY FROM THE MAKERS OF THE HERMANN SCHMIDT MG-1 SURFACE GAGE AND AN INTERAPID HORIZONTAL 312B-1 , LARGE FACE (1-1/2") .00050" TEST INDICATOR NEW IN THE BOX AS SHOWN. INDICATOR IS IN EXCELLENT NEVER USED CONDITION (215.00 CURRENT LIST!). ALSO INCLUDED IS THE INTERAPID SWIVEL CLAMP TO ATTACH TO THE FACTORY ARM-ALLOYED RODS! NEW THIS IS AN ALMOST $700 SET UP BUT NONE BETTER! BASE IS IN EXCELLENT USED CONDITION AS SHOWN WITH NO INITIALS OR ENGRAVING, ONE SMALL NICK ON SIDE. INDICATOR BOX IS LIKE NEW AND RED PLASTIC CASE WITH PAPERWORK. CHECK THE PICTURES AND SEE IF YOU DO NOT AGREE! BASE COMES STANDARD NOW WITH ONE 7-1/2" SMOKE CHROMED CENTERLESS GROUND 9/16" DIAMETER POST FOR 12" CAPACITY AS LISTED. COMES EQUIPPED AS SHOWN IN PICS.
THESE ARE WIDELY USED BY MACHINISTS AND TOOLMAKERS ALIKE. ITEM IS USED BUT IN VERY GOOD CONDITION AND IS SILKY SMOOTH! PLEASE CHECK ALL THE PICTURES FOR A GREAT GAGE! THESE WORK GREAT WITH YOUR .0005", .0001" OR .00005" INDICATORS DUE TO THE VERY FINE THREAD OF 1/4"X40 FINE ADJUSTMENT.
SQUARENESS CHECKS CAN ALSO BE PERFORMED OFF THE REAR OF BASE DUE TO REFERENCE SURFACE, IF YOU HAVE A CYLINDER SQUARE OR REFERENCE BAR. I HAVE MANY LISTED THAT WORK GREAT WITH THESE BASES FOR SQUARNESS CHECKS. CURRENT LIST ON THESE SURFACE GAGES IN MSC BIG BOOK IS OVER $375 FOR BASE ALONE!!!! BROWN&SHARPE INDICATOR IS ANOTHER $217.00 !!! WE HAVE SOLD SEVERAL AND EVERYONE LOVES THEM. WE ALSO USE THIS STYLE EVERY DAY WHEN GRINDING!
ANY QUESTIONS ASK ****@windstream.net
Quality Instruments for Discriminating Toolmakers.
Designed to simplify your job...
Engineered for efficiency and easy to use...
The innovative design of the MG-1 Gage makes it one of the most rigid
This rigidity greatly increases the repeatability of your indicator while
decreasing the number of adjustments necessary during use. The simplicity of
the mechanism results in fewer moving parts to repair or gnt replace.
The overall performance of this gage is most impressive.
* Spring steel front for rigidity.
* Hardened -40 screw with extra-long brass bushing.
* Blackened for appearance and rust resistance.
* Built-in bar for checking squareness.
* Hardened bottom with dirt grooves.
* Large diameter adjusting knob for sensitivity.
* Wrench hole in end of chromed rod for tightening/loosening.
* Spring-loaded indicator rod prevents nose-diving.
* 10" AND 6" chromed rod for tall work pieces.
