Kenosha Reuse Discussion Board > SOMERS, WI
> Commercial
> Automative
> Heinrich sheet metal punch * fabrication work tinsmith
Heinrich sheet metal punch * fabrication work tinsmith
This is a HEINRICH Co. metal punch.
This is as close to new as you will ever get. This was never used, only to do the 3 test pieces shown in pictures.
It has a 1/4" diameter punch and die in it. Other sizes are available up to 1/2" diameter.
I found this in the MSC Direct book, they stock it currently, along with punch/die sets.
The punch with one set of punch/die costs: $560.00.
The punch & die sets are $23.68 each.
I tested this on 3 different thicknesses of metal, tin can lid, piece of 20 ga. galvanized, and a piece of 14 to 16 ga. Punched quick and easy, can also do slotting and nibbling.
There are 2 allen wrenches, one for releasing punch and one for the die.
The handle slips over the cast iron punch arbor/bar. Height of punch is 26" with the handle on it. Front to back dimension is almost 14".
The arbor lever can be reversed for left hand operation, removing the 4 bolts on the front, slip out punch holder and the arbor can be pulled out and reversed to the other side.
