Kenosha Reuse Discussion Board > SALEM, WI
> Commercial
> Mechanical
> New
> No Warranty
> Okuma howa 3 axis vertical machining center, 17X12 tble
Okuma howa 3 axis vertical machining center, 17X12 tble
We are pleased to quote for you the following. Please note that these are approximate specifications only. We advise that you personally inspect this machine before purchasing it to verify the following information:
1-Used Okuma Howa 3 Axis Vertical Machining Center
Table Size...................................................................... 17.75 x 12.5
X Travel........................................................................ 22.83
Y Travel........................................................................ 14.17
Z Travel......................................................................... 19.68
Rapid X&Y................................................................... 630 /Min
Rapid Z.......................................................................... 472 /Min
Taper............................................................................. BT40
Spindle Drive Motor...................................................... 7.5/10 HP
Spindle Speed Range..................................................... 60-6000RPM
Tool to Tool, Chip to Chip............................................. 4-5/8-10
Tool Station................................................................... 20
Machine Weight............................................................. 9,900 Lbs
Twin Arm Tool Changer, Chip Auger with 2 Side Pans, Fanuc 0M Control, Automatic Pallot Changer with 2 Pallots
