Kenosha Reuse Discussion Board > SALEM, WI
> Commercial
> Industrial
> Used
> Plus Warranty
> Misco classic 250 (25% solids) floor finish 4 gal/cs
Misco classic 250 (25% solids) floor finish 4 gal/cs
Misco MPC Classic 250 (25% Solids) Floor Finish 4 gallons/case
A premium quality, high solids, metal cross-linked acrylic floor finish
designed to give exceptional initial gloss with minimum amount of coats.
Dries to a hard durable finish that withstands daily high traffic yet responds
well to low or high speed spray-buffing.
PREPARATION: If stripping is necessary, use a high quality product and
follow directions accordingly. If floor is in good condition and stripping is not
necessary, sweep up excess dirt and dust and then clean with a good quality
cleaner to remove dirt and oils. Follow with a thorough rinsing and allow to
FINISHING: If floor was stripped, use a good acrylic sealer to further prepare
the floor for finishing. Spread a liberal coat of finish evenly across the floor
with a clean mop or applicator. Allow each coat to dry at least 1 hour before
applying the next coat. Two or three coats are desired initially, depending on
the condition of the floor and gloss desired.
MAINTENANCE: The floor may be maintained using a quality floor cleaner
and damp mopping regularly. Spray buffing or mop-on restoring may also be
done after sweeping up loose dirt and dust. Follow directions for each product
This product meets the maximum content requirements for Volatile Organic
Compounds (VOCs) as established by state and Federal regulations.
