Kenosha Reuse Discussion Board > SALEM, WI
> Commercial
> Automative
> Refurbished
> Seamless gutter machine with enclosed trailer
Seamless gutter machine with enclosed trailer
KWM Panther: Purchased September 2007. Total of maybe 1500' of gutter ran through it. Never have I had any issues from this. Loads perfect, runs a true and straight gutter, and I've always transported it with stock fed into it. All the switches work, and the motor is quiet. I also bought the extra uprights and spools for this so that it is a true triple spool set up. All the uprights are KWM's Turnstyle uprights which allow it to be turned to correct position even after the coil has been loaded. The guillotine cut off has never hung up and cuts straight and has been oiled frequently. It has 7 Chromoly rollers, all of which look spotless. This Machine has been in the trailer it's whole life. Also included with the machine is 2 tripod standoffs for running out gutter.
2007 Cargo Express: Purchased also in September of 2007. Bought this the day before picking up the machine so that I could load the machine directly into the trailer. This trailer really is a beauty. All aluminum sides with a seamless aluminum top, which has never leaked. It's tandem 3,500 # axels pull straight. The hubs have the quick grease inserts on them. It has fully functional electric brakes, and the tires look good still as well. I'm not exactly sure how many miles are on the trailer, but I believe it's safe to say it's less than 5,000 miles. Inside, it features 3/4" Advantech flooring, 3/8" plywood walls trimmed with 1/4" veneer plywood. It also has 4 tie down hooks inside to secure load if needed. I've spent a lot of time fabricating extras into this trailer to make it specific use for gutters. To load coil, there is an electric winch wired into it (have to have it hooked to a truck-no extension cords needed for this) and a bracket I made which hooks to the spool axel and will lift it on a trolley (4" I-Beam) so there is no need to load coil by hand! Up front, is a set of shelves built in to store stock, gutter components, tools, etc. also made of 3/4" Advantech. Shelving was built into the right (passenger) side of the gutter machine to store downspouts.
The Extras: Everything you need to start hanging gutter today. You have 215# of pebble clay coil stock, over 350 elbows (A&B included), strip miters, zip screws, gutter screws, almost a full 1,000 count box of hangars (good ones with the clip), downspouts, gutter sealant - You are ready. I'm also including the tools needed: 18v cordless Hitachi drill with 2 batteries and charger, 1/4" gutter bit, downspout crimpers, 2x3 punch-out tool, 4' level, framing square, caulking guns, and 2 box miter saws if you prefer to cut that way. ALSO: 2 ladder stand-offs, 50' 10 gauge cord (not pictured), and 2 Little Giant Ladders (also not pictured).
This is really turn key and ready to work. Just show up with your tool-bags and have fun.
