Kenosha Reuse Discussion Board   >   NORTH CHICAGO,IL   >   Commercial   >   Electrical   >   New   >   Honeywell RM7840M1017 **rebuilt** get a $100 refund.

Honeywell RM7840M1017 **rebuilt** get a $100 refund.


Do you have an old unit? Send it in to us and if we determine that it is in satisfactory condition, we will refund you $100! Contact us for complete information.
This listing is for a rebuilt RM7840M1017. We disassemble these units and replace worn components then test them for 2hrs and quality inspect each unit before being sold to you. They each have our two year warranty. If the unit fails during this time we will either fix it for free or replace the unit. Qualified technicians are on hand to help with any technical questions with installation.
Our Rebuilt Microcomputer Controls are used to provide timed control of specific burner components. These components can include burner motor, firing rate motor, ignition of pilot, and the opening of main fuel valves. *Some models require purge cards and are sold separately and come in various times. Contact us for ordering information on these purge cards.
Safety Shutdown will occur if there is **flame failure during the run period, or if the interlocks open the unit will go to alarm. At this time, the unit is locked out until the operator manually resets the safety switch.
At start up, the unit will go to alarm if there is a flame present, or if the pre-ignition interlocks are open.
These Programmers utilize Microcomputer technology to monitor the system for unsafe conditions, then ***displays them as errors for easy identification.
Units come with a Test Run switch.
*Purge timing cards come in various times and are required
**Amplifiers are also required; call us with your specific Flame Detector
*** Some RM7800 series controllers come with or without displays.
**************Attention**************
These rebuilt C7012E1104's are FM approved! We are the only facility to be approved for rebuilt FSG units in the country. We have other Honeywell rebuilt FSG and Controls on hand. Email us if you re interested.
Actual listing from the Factory Mutual Approval Standard Handbook.
FM Approvals are intended to verify that the products and services described will meet stated conditions of performance, safety and quality useful to the ends of property conservation. The purpose of FM Approval Standards is to present the criteria for FM Approval of various types of products and services, as guidance for FM Approvals personnel, manufacturers, users and authorities having jurisdiction.
Products submitted for Approval shall demonstrate that they meet the intent of the Approval Standard, and that quality control in manufacturing and/or applications shall ensure a consistently uniform and reliable product or service. FM Approval Standards strive to be performance-oriented and to facilitate technological development.
For examining equipment, materials and services, FM Approval Standards:
A. Must be useful to the ends of property conservation by preventing, limiting or not causing damage
under the conditions stated by the Approval listing; and
B. Must be readily identifiable.
Continuance of Approval and Listing depends on compliance with the Approval agreement, satisfactory performance in the field, on successful re-examinations of equipment, materials, and services as appropriate, and on periodic follow-up audits of the manufacturing facility or service/application.
FM Approvals LLC reserves the right in its sole judgment to change or revise its standards, criteria, methods, or procedures.



Honeywell RM7840M1017 **rebuilt** get a $100 refund. Honeywell RM7840M1017 **rebuilt** get a $100 refund. Honeywell RM7840M1017 **rebuilt** get a $100 refund.