Kenosha Reuse Discussion Board > NORTH CHICAGO,IL
> Commercial
> Automative
> New
> Devlieg microbore 40M-14 range 4-5 boring head 40 taper
Devlieg microbore 40M-14 range 4-5 boring head 40 taper
DeVlieg Microbore 40M-14 Range 4-5 Boring Head 40 Taper
DeVlieg microbore boring head number 40M-14. Used but in very good condition... it does have CRW engraved on one side and again on the end of it. Comes just as pictured with the dial and cutter and the cutter still has a bit of life left in it. The holder measures approximately 3.24 inches in diameter at it's largest point (not including the bit).
ALWAYS CHECK BELOW FOR ADDED INFORMATION as it may be important... added info will appear under any shaded areas near the BOTTOM of the page.
