Kenosha Reuse Discussion Board > GURNEE, IL
> Commercial
> Mechanical
> Refurbished
> Ford rear pto. flat belt drive attachment. 1-3/8" 6 spl
Ford rear pto. flat belt drive attachment. 1-3/8" 6 spl
Ford Tractors that have rear PTO drives can use this attachment PTO flat belt drive converter. aka PTO TO BELT DRIVE CONVERTER.
The belt pulley attachment drives off the tractors pto 1-3/8" (d) 6 spline shaft and allows implements or attachments to be driven by a wide flat belt from this pulley.
Used, original belt pulley, for 8n, 9n, 600, 700, 800, 900, Ford tractors as well as other series tractors with the rear PTO, this was on a 2000 series Ford tractor.
I assume, others have the same Ford bolt up, 4 1/4 C to C mounting, & 1-3/8inch 6 spline drive shaft. I am told it will fit any Ford tractor with those spec's.
Mechanically the unit seems to function perfectly. It turns smoothly, the casting housing as shown has slight amounts of rust, but most paint is in original but used condition and is about ready to use. After you check it out & maybe change the oil. This has always been stored inside, on or off the tractors it was used on.
The belt drive surface of the pulley is approximately 6 3/4 inches in width and the pulley diameter is 8 3/4 inches wide. My pictures have most of the measurements of the converter.
I found a picture of a similar PTO drive on a tractor posted at the following site. http://home.att.net/~jmsmith45/8nacc.htm
I would think these are of days gone by, as most flat belt tools & utilities are direct pto drive today.
But for the collector or special need tractor owner, this might be a one of a kind item he / she has been searching for.
Should you have any questions please ask.
