Kenosha Reuse Discussion Board > GURNEE, IL
> Commercial
> Industrial
> Used
> Laser cutting system with all accessory equipment
Laser cutting system with all accessory equipment
Complete laser cutting system built by Lasercut Inc. of Branford Ct. in 1991.
Purchased used in 2002 for $140,000.00
Motion table with 100 inch X 50 inch travel and 1500 lb. load capacity.
Pneumatic and manual clamping systems
Chiller with all necessary plumbing (New in 2002)
Beam delivery system with triple gas capability; air, oxygen and nitrogen (regulators included)
GE Fanuc OL Numerical Control with RS232 serial connection
Exhaust system with 1500 cfm Dayton blower and ductwork (New in 2002)
Two-cylinder Speedair air compressor with refrigerator dryer (New in 2002)
Windows Computer System running Cimcad software with Smoother and NC Link editor (Upgraded in 2008)
Maximum travel speed of table is 750 inches per minute. Cutting speed depends on material. Accuracy is +/- 0.0010 inches per foot and repeatability of +/- 0.0005 inches.
Motion table was factory reconditioned in 2002 at Lasercut Inc.
GE Fanuc refurbished the laser on site in 2005 with new optics, discharge tubes and Roots blower for over $35,000.00 GE Fanuc will continue to service the laser and control for the foreseeable future.
System continues to be used at low power for only one shift to cut wooden shapes as it has for the past eight years.
Seller will provide demonstration and training at current location.
