Kenosha Reuse Discussion Board > GURNEE, IL
> Commercial
> Industrial
> Refurbished
> 7/8" cobalt hsc M42 end mill cutter 3-5/8" long flute
7/8" cobalt hsc M42 end mill cutter 3-5/8" long flute
Cutting diameter is .878" Just .003" OVER 7/8"
This is a RIGHT HAND cutter even though the one in the photo is LEFT HAND
This is not an actual photo but it is pretty much identical to the one in the photo but this one is approx. 2" longer than the one in the photo. I have had a few of them in the past that were pretty much all the same so I have used this same photo for each one.
