Kenosha Reuse Discussion Board > GURNEE, IL
> Commercial
> Electrical
> Refurbished
> No Warranty
> Somma randl hardinge dv-59 lathe multi tool hold cutter
Somma randl hardinge dv-59 lathe multi tool hold cutter
SOMMA RANDL HARDINGE DV-59 LATHE MULTI TOOL HOLD CUTTER
This was on a Hardinge DV-59 Metal Lathe. It had the multi turning turret on it. This tool would slide down in the holes on the unit, (the last picture shows what part the tool went in on the lathe, you are NOT receiving the tool in the last picture).
I don't know if it will work on any other type of lathes or not.
The shaft size is 5/8" round, it holds two cutting tool bits.
This tool is marked Somma #00.
***Please click on each photo for greater detail***
**LOOK AT MY OTHER ITEMS, YOU NEVER KNOW WHAT YOU WILL FIND**
