Kenosha Reuse Discussion Board > CALEDONIA, WI
> Commercial
> Mechanical
> Refurbished
> No Warranty
> Nohau keil emul pc/usb-jtag & 2X MCB2100 boards
Nohau keil emul pc/usb-jtag & 2X MCB2100 boards
NOHAU KEIL EMUL PC/USB-JTAG & 2X MCB2100 BOARDS
The Keil ULINK family of USB-JTAG Adapters connect your PC's USB port to your target system (via JTAG or similar debug interface) and allow you to debug embedded programs running on target hardware.
The ULINK adapters enable you to:
* Download programs to your target hardware
* Examine memory and registers
* Single-step through programs and insert multiple breakpoints
* Run programs in real-time
* Connect using JTAG and Serial Wire mode
* On-the-fly debug of Cortex-Mx devices
* Examine Trace information from Cortex-M3
Two (2) Keil MCB2100: 32-bit ARM Evaluation boards for NXP
The Keil MCB2100 Evaluation Board introduces you to the NXP (founded by Philips) LPC2100 ARM family and allows you to create and test working programs for this advanced architecture.
The Keil MCB2100 Evaluation Board connects to your PC using the serial port (for Flash download using FlashMagic) or the JTAG interface (for program debug using the Keil ULINK USB-JTAG Adapter and the Vision IDE and Debugger).
Two Serial and two CAN interfaces make this board a great starting point for your next ARM project.
The MCB2100 Evaluation Board includes the following:
* MCB2100 Evaluation Board,
* RealView MDK-ARM Evaluation Tools
