Kenosha Reuse Discussion Board > SOMERS, WI
> Commercial
> 1980 cincinnati monoset tool & cutter grinder w/tooling
1980 cincinnati monoset tool & cutter grinder w/tooling
1980 CINCINNATI MONOSET TOOL & CUTTER GRINDER w/TOOLING
MODEL: MT S/N: 3152A0180-0023 NEW: 1980
WORKHEAD SWING OVER MAIN SLIDE, MAX. DIA. ... 12"
MAX. WORKHEAD COLLET HOLE DIA. .............. 1-1/4"
MIN. WORKHEAD COLLET HOLE DIA. .............. 0.12"
MAX. GRINDING WHEEL DIA. .................... 4"
MAX. LENGTH OF WORK BETWEEN SPINDLE &
TAILSTOCK CENTER .......................... 6"
LONGITUDINAL .............................. 5-3/4"
CROSS ..................................... 5-3/4"
MAX. TURNTABLE SWIVEL ..................... 235 DEG.
ABOVE AND BELOW CENTER .................... 40 DEG.
(3) WHEELHEAD SPINDLE SPEEDS ................ 4,000,
(1) WORKHEAD SPINDLE SPEED ................. 436 RPM
APPROXIMATE WEIGHT ........................ 1,500 LBS.
1/4 HP 3/60/230-460 VOLT MOTORIZED WORKHEAD
1/2 HP 230-460 VOLT WHEELHEAD DRIVE MOTOR
-7 GRINDING WHEEL MANDRELS; ONE FOR EACH WHEEL SUPPLIED
-1 GRINDING WHEELHEAD TOOTHREST AND EXTENSION BAR FOR
-1 SPRING-LOADED INDEX PAWL FOR WORKHEAD FRONT INDEX
-13 STRAIGHT CYLINDRICAL COLLETS FOR THE WORKHEAD SPINDLE
WITH HOLE DIAMETERS IN INCH SIZES THAT ACCEPT STRAIGHT
CYLINDRICAL DIAMETER WORKPIECES; AND, INCLUDING AN
ADAPTER ("C" TO "A") THAT ACCOMMODATES TEH COLLETS SMALLER
THAN 1/2" SIZE. THE COLLETS ARE:
7 - SERIES "A" (FITS INTO THE "C" TO "A" COLLET ADAPTER,
WHICH MOUNTS DIRECTLY INTO THE SPINDLE NOSE
1/8",3/16", 1/4", 5/16", 3/8", 7/16" AND 1/2"
6 - SERIES "C" (MOUNTS DIRECTLY INTO SPINDLE NOSE
5/8", 3/4", 7/8", 1", 1-1/8" AND 1-1/4"
-6 TAPER HOLE COLLETS, "C" SERIES, FOR THE WORKHEAD
TO ACCOMMODATE TAPER SHANKS OF #2, 3 AND 4 MORSE
TAPERS, AND #5, 7 AND 9 BROWN & SHARPE TAPERS
-1 WOODEN RACK FOR HOLDING 1 SET OF CYLINDRICAL COLLETS
-3 INDEX PLATES FOR THE LEAD MECHANISM INDEXING
DEVICE OF 8,10 AND 12 DIVISIONS
-1 ADJUSTABLE TAIL-CENTER SUPPORT
-1 DIAMOND BRACKET, WITH WORKREST, INCLUDING ONE
